Acoustic properties of the disordered relaxor ferroelectric PbSc1/2Ta1/2O3

The behavior of acoustic phonons in crystals of a relaxor ferroelectric, namely, the lead scandium tantalate PbSc_1/2Ta_1/2O₃ (PST), is studied in the vicinity of the diffuse phase transition. The behavior of longitudinal and transverse acoustic phonons in a PST single crystal is examined using Brillouin scattering. The phonon subsystem is found to behave anomalously in the vicinity of T = 297 K, which can probably be assigned to the existence of a phase transition. Analysis of the results obtained yields the values of the elastic moduli C₁₁, C₁₂, and C₄₄ for the cubic phase of the crystal over a wide temperature range.     

Kinetics of polarization reversal in irradiated thin PZT films

The effect of irradiation with electrons and neutrons and of exposure to synchrotron radiation on cyclic switching of polarization in thin films of lead zirconate titanate Pb(Zr,Ti)O₃ (PZT) was studied. It is shown that variations in the shape of switching currents are due to the generation of a spatially nonuniform bound internal field with account for an increase in the rate of bulk screening caused by irradiation. A correlation between structural variations and the evolution of the switching current measured during and after irradiation is established.     

Theoretical photoelectronic spectra of molybdenum, tungsten, and rhenium disilicides

Photoelectronic spectra of volume samples of molybdenum, tungsten, and rhenium disilicides are theoretically investigated as functions of the excitation energy (hv = 12–1486 eV) by the method of linearized attached plane waves. The main contribution to the spectrum at low (hv = 12–52 eV) and very high (hv = 1486 eV) excitation energies is given by the metal d-states, while the contribution of the Si p-states is dominant at intermediate excitation energies. An analysis of the calculated results demonstrates that the main peak of the photoelectronic spectra is displaced by 0.2 eV toward the bottom of the valence band when going from MoSi₂ to WSi₂; it is displaced by 0.3 eV when going from WSi₂ to ReSi_1.75. __________ Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 7, pp. 75–80, July, 2006.     

Conformational characteristics of polycaproamide in dimethylacetamide containing lithium chloride

The viscosity behavior, index of refraction, and density of dilute polycaproamide solutions in DMAc containing lithium chloride have been studied. On the basis of temperature dependences of the index of refraction and the density of solutions, the θ-condition of polycaproamide solutions in DMAc containing 2.5% lithium chloride is estimated as 21.3°C. From intrinsic viscosity [η] measurements, the coefficients of swelling of a polymer coil, the mean-square distance between chain ends, and other parameters of macromolecules in solution are calculated.     

Modification of single molecule fluorescence by a scanning probe

We examine the optical near-field interaction between different types of scanning tips and single oriented fluorescent molecules. We demonstrate the influence of a tip on the excitation intensity as well as on the integrated fluorescence signal, the excited state lifetime, and the angular emission of single molecules. By using a standard model describing the radiation of an oscillating dipole close to a nanosphere or a flat interface, we interpret our observations and describe some central criteria for obtaining fluorescence enhancement or quenching. PACS 33.80.-b; 07.79.Fc; 78.90.+t     

Optical properties of in situ doped and undoped titania nanocatalysts and doped titania sol-gel nanofilms

In this paper we present spectroscopic properties of doped and undoped titanium dioxide (TiO₂) as nanofilms prepared by the sol-gel process with rhodamine 6G doping and studied by photoacoustic absorption, excitation and emission spectroscopy. The absorption spectra of TiO₂ thin films doped with rhodamine 6G at very low concentration during their preparation show two absorption bands, one at 2.3 eV attributed to molecular dimmer formation, which is responsible for the fluorescence quenching of the sample and the other at 3.0 eV attributed to TiO₂ absorption, which subsequently yields a strong emission band at 600 nm. The electronic band structure and optical properties of the rutile phase of TiO₂ are calculated employing a fully relativistic, full-potential, linearized, augmented plane-wave (FPLAPW) method within the local density approximation (LDA). Comparison of this calculation with experimental data for TiO₂ films prepared for undoped sol-gels and by sputtering is performed.     

High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayers

High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayer (ML) up to 600 °C have been studied and reported in this paper. Ti/Ni multilayer samples having constant layer thicknesses of 50 Å each are deposited on float glass and Si(1 1 1) substrates using electron-beam evaporation technique under ultra-high vacuum (UHV) conditions at room temperatures. The micro-structural parameters and their evolution with temperature for as-deposited as well as annealed multilayer samples up to 600 °C in a step of 100 °C for 1 h are determined by using X-ray diffraction (XRD) and grazing incidence X-ray reflectivity techniques. The X-ray diffraction pattern recorded at 300 °C annealed multilayer sample shows interesting structural transformation (from crystalline to amorphous) because of the solid-state reaction (SSR) and subsequent re-crystallization at higher temperatures of annealing, particularly at ≥400 °C due to the formation of TiNi₃ and Ti₂Ni alloy phases. Sample quality and surface morphology are examined by using atomic force microscopy (AFM) technique for both as-deposited as well as annealed multilayer samples. In addition to this, a temperature dependent dc resistivity measurement is also used to study the structural transformation and subsequent alloy phase formation due to annealing treatment. The corresponding magnetization behavior of multilayer samples after each stage of annealing has been investigated by using Magneto-Optical Kerr Effect (MOKE) technique and results are interpreted in terms of observed micro-structural changes.     

Effects of in situ thermal annealing on the structural, optical, and electrical properties in Hg0.7Cd0.3Te epilayers grown on CdTe buffer layers

Scanning electron microscopy (SEM), Fourier transform infrared (FTIR) transmission, and Hall effect measurements were performed to investigate the structural, optical, and electrical properties of as-grown and in situ-annealed Hg_0.7Cd_0.3Te epilayers grown on CdTe buffer layers by using molecular beam epitaxy. After the Hg_0.7Cd_0.3Te epilayers had been annealed in a Hg-cell flux atmosphere, the SEM images showed that the surface morphologies of the Hg_0.7Cd_0.3Te thin films were mirror-like with no indication of pinholes or defects, and the FTIR spectra showed that the transmission intensities had increased in comparison to that of the as-grown Hg_0.7Cd_0.3Te epilayer. Hall-effect measurements showed that n-Hg_0.7Cd_0.3Te epilayers were converted to p-Hg_0.7Cd_0.3Te epilayers. These results indicate that the surface, optical, and electrical properties of the Hg_1 − xCd_xTe epilayers are improved by annealing and that as-grown n-Hg_1 − xCd_xTe epilayers can be converted to p-Hg_1 − xCd_xTe epilayers by in situ annealing.     

Current distribution and giant magnetoimpedance in composite wires with helical magnetic anisotropy

The giant magnetoimpedance effect in composite wires consisting of a non-magnetic inner core and soft magnetic shell is studied theoretically. It is assumed that the magnetic shell has a helical anisotropy. The current and field distributions in the composite wire are found by means of a simultaneous solution of Maxwell equations and the Landau–Lifshitz equation. The expressions for the diagonal and off-diagonal impedance are obtained for low and high frequencies. The dependences of the impedance on the anisotropy axis angle and the shell thickness are analyzed. Maximum field sensitivity is shown to correspond to the case of the circular anisotropy in the magnetic shell. It is demonstrated that the optimum shell thickness to obtain maximum impedance ratio is equal to the effective skin depth in the magnetic material.